Скачать с ютуб EASY DIY SUV CAMPER CONVERSION - PART 1: BED PLATFORM в хорошем качестве

EASY DIY SUV CAMPER CONVERSION - PART 1: BED PLATFORM

Tools used: BLACK & DECKER 12V Power Drill (with bits that fit chosen screws and a 1” flat wood bit). CRAFTSMAN 13.0 AMP 7 1/4” Corded Circular Saw Wood Rasp Rounded Wood File PORTLAND SAW 6” Coping Saw w/ High Carbon Steel Blade WARRIOR Angled Sanding Sponges (150 Grit/Fine) (4) PITTSBURGH 24” Quick Release Bar Clamps Materials needed: (2) Panels of Sanded Plywood POWERPRO 8 x ¾” T20 Interior Multi-Material Screws POWERPRO 8 x 1 ½” Exterior Multi-Material Screws (4) 3” Brass Hinges (16) ZMAX Large L Angle Brackets (1) Roll of NEEDLEBOND Interior/Exterior carpet (1) LOCTITE Spray Adhesive Glue (1) GORILLA Wood Glue (2) Slings, Straps or Rope for Front Panels Measurements: Below were our initial plywood measurements but as you saw we made some adjustments with the curved cuts and sanding on the back support panels. The below measurements should be adjusted to your specific make/model of SUV. The back of my 2018 Subaru Forester is not level which is why the support panels are various heights. (1) 31.5” x 42” (Back Top Plywood Panel and Carpet) (1) 26.5” x 42” (Middle Top Plywood Panel and Carpet) (2) 16” x 21” (Both Front Top Plywood Panels and Carpets) (3) 9” x 31.5” (Back Support Panels – these were then cut at an angle - 8.5” on one end and 7.5” on the other. They were then rounded and sanded as shown in the video.) (1) 5” x 42” (Middle Support Panel) (1) 5.5” x 42” (Middle Support Panel) Special Thanks: Bed Platform design inspired by “Ruby Sue the Subaru” blog post at www.bonjourbecky.com. Music by: Johnusworld – Music for Video Creators    / @nocopyrightmusic-copyrightfree   Follow our adventures on Instagram @rachelmorgan173 !! Stay tuned for Part 2: Accessorizing Your SUV Camper !!