Русские видео

Сейчас в тренде

Иностранные видео


Скачать с ютуб Talking Atomic Watch Reset Procedure Step 1 в хорошем качестве

Talking Atomic Watch Reset Procedure Step 1 11 лет назад


Если кнопки скачивания не загрузились НАЖМИТЕ ЗДЕСЬ или обновите страницу
Если возникают проблемы со скачиванием, пожалуйста напишите в поддержку по адресу внизу страницы.
Спасибо за использование сервиса savevideohd.ru



Talking Atomic Watch Reset Procedure Step 1

Reset the watch when the spoken time does not match the time shown on the watch face: 1. First make sure the watch is running normally. 2. Hold 8 o'clock button for more than 5 seconds until the watch says "Set Alarm, Press10 o'clock button to set." 3. Push 8 o'clock button 5 more times until the watch says "Second-Hand Alignment, Press 10 o'clock button to set." 4. Press the 10 o'clock button. Next the watch says, "Press 2 o'clock button to set, 8 o'clock button to confirm." Now Wait until the second hand spins to a new position and then stops moving. 5. When the second hand has stopped moving then instead of pressing the 2 o'clock button, press and HOLD the 4 o'clock button until the second hand starts to fast spin. 6. Keep an eye on the hour, minute and second-hands as they move around very near to the straight up12 o'clock position. This may take some time depending on where the hands were when the process started. 7. Stop the fast movement a minute or so before the second hand reaches the 12 o'clock position (around 11:58:00) by pressing the 4 o'clock button. (NOTE: You can stop and start the fast movement anytime by pressing 4 o'clock button while the hands are spinning.) 8. Press and release the 4 o'clock button repeatedly and quickly each time to adjust the second-hand by one second at a time to move it up to exactly to the 12 o'clock position (12:00:00). (If you accidentally go past the 12, start this entire process again. Note that you will have to wait until the second hand starts moving again before you can start over which will take about 10 minutes or so.) 9. Once all hands are aligned at the 12 o'clock position (12:00:00) do not push any other buttons and wait 10 minutes for the watch to pick up the signal. If the signal is not found the watch will start running from 12 o'clock. Leave the watch where it can pick up the signal overnight. 10. Once your watch picks up the time signal, set your watch to the correct Time Zone.

Comments