Скачать с ютуб Newbie figuring out how to use LE Wilson neck die в хорошем качестве

Newbie figuring out how to use LE Wilson neck die

This is what Dan from LE Wilson said after he watched my video: Order of steps to set up die. Unwrap and inspect Wipe all excess shipping oil off Remove cap and punch assembly Check one of your fired pieces of brass to make sure it fits well in the die. If it is protruding out the top of the die. They you may have a slightly oversized chamber and we will need to open up your die a bit. We do not charge for this service. Now it is important to note all brands of brass will vary a little in the thickness of the case wall. Measure for the brand and batch you are sizing. Measure and figure bushing size. By subtracting .003 you are allowing .001” spring back to give you about .002” grip on bullet. Insert Bushing with numbers up. Replace cap and punch assembly. Use decap case to line up brass Best to check the first round with the bullet seating to make sure you have the tension you want/need on the neck. You are now ready to size. If you switch to a different batch of brass or brand you will need to refigure bushing size.