Скачать с ютуб AltRider T7 Tail Tidy Install в хорошем качестве

AltRider T7 Tail Tidy Install

The OEM tail fender on the Tenere 700 is not only eye sore, it is as heavy as it is large. To remedy this AltRider designed a lightweight weight Tail Tidy Fender Eliminator for the Yamaha Tenere 700. The fender eliminator is formed from a single sheet of 5052 aluminum to reduce weight and finished in a textured black powder coat to blend in with the rear plastics. As the only aluminum option on the market, the AltRider Tail Tidy is the lightest design available, using single piece construction and gussets to maximize the strength and rigidity. Formed from a single sheet of 5052 aluminum Single piece construction utilizes gussets to maximize the strength and rigidity Lightweight, replaces 3.1 lbs (1.4 kg) of OEM equipment Blinker mounts accept any 10 mm aftermarket stem Textured black powder coat finish AltRider Tail Tidy Fender Eliminator for the Yamaha Tenere 700 is not compatible with the large OEM blinkers however the blinker mounts in the tail tidy are drilled for any 10 mm aftermarket stem. To keep things tidy the cable routing is made convenient with wire routing slots for cable-ties and an entry hole to route cables up into the tail plastics. The license plate illumination and blinkers are located tightly up under the brake light to instantly clean up the rear lines of the bike, and looks great from any angle. Securely mount your license plate using four pre-drilled holes, which prevents any stress-cracks found on two hole designs. The angle of the plate keeps it tight to the bike, and out of the way of your tire, even with aggressive knobbies, in the event of full compression. Available with the Cyclops Multi Function 3.0 Turn Signal Kit for the Yamaha T7. Cyclops have stepped it up with a brighter setup for the Multi Function 3.0 Turn Signal Kit; including all new bodies, lenses emitters and stems and also adding a running and brake light function. All in an extremely rugged rubber stock to help prevent damage from a tip over or impact with brush, trees etc. Bends back 90 degrees or more. These are durable but not unbreakable. A minimalistic blinker setup that adds brake light and front running light functions, there is also a rear running light function option as well. Now easily turn your blinkers into additional running lights and or brake lights (rear) for added visibility.Bright white light in the front and red in the rear. Rear red brake lights will come on sequentially flashing twice then go to solid red! Not compatible with large OEM blinkers License plate mounting screws NOT included Get it here: https://www.altrider.com/altrider-tai... 0:00 – 1:50 Intro 1:50 – 9:50 Prepping the bike & removing body panels 9:50 – 23:40 Blinkers and electronics 23:44 – 26:00 Attaching the bodywork 26:00 Securing the tail tidy