Скачать с ютуб How To Use DAP 2in1 Wall & Ceiling Spray Texture в хорошем качестве

How To Use DAP 2in1 Wall & Ceiling Spray Texture

Quick Start Guide for 2 in 1 Wall & Ceiling Spray Texture - UNLOCK the tab by bending backwards and RELOCK by pressing back into place when you’re done. This is a re-locking tab to avoid accidental sprays when stored - ADJUST nozzle up or down to desired spray angle. The nozzle can rotate up to 60 degrees. - TWIST nozzle to desired texture size fine, medium, or heavy. - SHAKE can upside down vigorously for one minute after hearing mixing marble moving freely in the can. IMPORTANT before applying, spray a quick burst of spray texture onto scrap materials to activate and ensure proper flow. - SPRAY holding can approximately 12- to 18-inches away from surface using intermittent bursts, sweeping across the repair in a quick, continuous motion. For superior blending, feather texture into surrounding repair area using the can. Add coverage as needed to match texture density. ALWAYS point the nozzle away from face and people. - FINISH your project by sanding or painting the repaired area. Spray texture only needs 30-minutes of dry time before you can sand or paint. Dry time may be longer in cooler/humid conditions or with thicker applications. Follow paint manufacturer’s instructions for best results. For exterior applications, use an exterior grade paint. - CLEAN-UP tools and area with towel and warm water. Be sure to remove any texture build up from tip/nozzle to prevent material drying on nozzle, place nozzle in the upright position, invert can, pointing the top straight down. Spray onto a disposable surface until no texture sprays - STORE adjust spray angle to starting position and re-lock using tab.