Скачать с ютуб Tugboat Dual Camera #6 - Voith Schneider Controls - Drydock в хорошем качестве

Tugboat Dual Camera #6 - Voith Schneider Controls - Drydock

After being overhauled, the MSC Korea was ready to leave the drydock complex. The company that did the overhaul (Engine Deck Repair) did a great job and allot of work. The 2 propellers you see at the beginning of the video are brand new propellers which are meant to replace old props on the ships. They both have a weight of aprox 60ton/each They have a new design which will make the ship sail slower, but with much more fuel efficiency which is good for the environement. A summary of the work done by the company : * The entire hull was given a fresh layer of paint (12.000m²) which consumed about 45.000liter of paint. * Propellershaft was refurbished, which needed the removal of the propeller from it's shaft. * Some engineroom maintenance (replacing old pipes and valves) * Bearings of the main engine and generators replaced * Electrical systems checked and replaced where needed * Deck winches got an overhaul, and also the anchorchain was checked for damage/strenght Great work by EDR ! Check their facebook page for more info : https://www.facebook.com/ENGINEDECKRE... Video Timestamps : 00:01 2 Large ships propellers from +- 60 Tonnes each 01:00 Moving over to the bow of the ship in order to connect the towingcable 03:15 Positioning ourself to the bow of the ship 04:20 Heaving line thrown on the deck 04:55 Heaving line + Runner going up 05:45 Winching out towingcable 06:51 Confirmation that towing cable is secure on the ship 07:10 winching out towingcable to the desired lenght 08:05 Slacking mooring lines 09:50 Ships engine going astern 13:35 Preparing to swing the bow over to starboard 15:50 Swining manoeuvre completed 15:55 Ships horn is tested briefly 17:59 15 minutes later in the journey 22:01 In front of the lock preparing to enter the lock (5-6 beaufort wind coming from the portside) 29:30 Strong winds pushing the ship to starboard which forced us to pull to portside at full power to prevent the ship from hitting the wall. The ship also picked up some speed by doing that because we also pull forward. The stern tug was asked to put the brakes on a little later. 34:35 Pilot asked us to push on the bow of the ship so we winched in the cable at went to the bow. 35:42 Pilot asked us to pull the ship foward to prevent the front line from breaking. 40:00 Confirmation of the pilot to disconnect the tug 44:00 Leaving the lock astern 47:00 Mooring the tug to get the next assignment 1 hour later. 49:55 Lowering RPM to stationary 50:15 Shutting down engines 50:35 Shutting down generator If you guys like my videos, please write a comment, give a thumbs up and share this video on your facebook-wall :) It takes me 2 days of editting and processing for each video, so i'll be very happy if you share these for me. If you didn't like it please write it in the comments also and i'll see if i can do anything about it :) Thanks for watching !! Note : If anyone recognizes himself in this video and you don't like that, please contact me and i'll delete the video or i will blur you out.