Русские видео

Сейчас в тренде

Иностранные видео


Скачать с ютуб Fix PS5 Disc Noise в хорошем качестве

Fix PS5 Disc Noise 2 года назад


Если кнопки скачивания не загрузились НАЖМИТЕ ЗДЕСЬ или обновите страницу
Если возникают проблемы со скачиванием, пожалуйста напишите в поддержку по адресу внизу страницы.
Спасибо за использование сервиса savevideohd.ru



Fix PS5 Disc Noise

From: https://hardware.support.playstation.... What you will need before you begin: A well-lit room with a table to work on. A #1 Phillips or Cross Hatch screwdriver works best. A small flashlight (optional). Turn off the PS5™ system and disconnect the AC cord. Disconnect all cables from the system. Remove the stand from the PS5 system. Place your palms on the system’s glossy panel and let your fingers rest on the far side of the system. Place the system sideways on a clean, flat surface in front of you, so that the front of the system is facing you. You're going to remove the bottom panel that has the disc slot from the PS5. The top panel that has a PS logo on it should be facing the table. Place your palms on the top of the panel, near the back corner of the system, and grip the edge of the panel with your fingers. Lift the corner of the panel up, away from the system until the panel shifts a couple of centimetres. You will hear a click and the panel will move a couple of centimetres. Lift the panel off, starting from the right side. Once the panel has been removed, look for four circular pieces on the bottom of the optical drive. Beside these is a circular dust cover of black plastic. Carefully peel this dust cover away to reveal the screw beneath. Set the dust cover to one side for now. Turn the screw clockwise until the disc can be seen peeking out of the disc slot. This may require several turns of the screw. Very little effort is required to turn the screw. Grab the disc by hand and pull it out of the disc slot. Use the black, circular dust cover to cover the screw. Replace the bottom panel by positioning it over the exposed section of the system, a couple of centimetres away from the edge. Slide the panel back into place until it clicks into position. Reconnect all cables and the AC cord. Turn on the system to check that everything is working properly. This is normal, and simply means that it is reading the disk information at a faster rate to load all the data more effectively. #SHORTS

Comments