Скачать с ютуб How to reupholstery your rear 2CV seat with seat covers with sides в хорошем качестве

How to reupholstery your rear 2CV seat with seat covers with sides

"We are going to show you how to reupholstery your rear 2CV seat with seat covers with sides." "Start by inserting the base rods into the canvas." "Attach the elastics to the base rods." "A small tip, make sure the stitching on the canvas faces upward.” "You will notice that we have fixed the elastics at the extremities." “Two elastics in the middle.’ “You can now fit the rest of the elastics.” “Once you have finished installing the seat canvas …” “… follow the same procedure for the back rest.” “Once the canvases are installed, you can place the seat sponge.” “Don’t forget to make a small cut for the rear seat frame bar.” "You will notice that the seat sponges have two different surfaces." "The glue will be applied to the sponge side." "Make sure that the glue is well spread around the sides and into the corners." "We are using a neoprene contact adhesive, so we will spread it along the frame too." "Let the glue dry for 2 minutes, then apply the sponge to the seat frame." "Position the sponge for the back rest, and cut around the rounded corners." "As for the other sponge, apply the glue making sure it is well spread." "Apply the glue to the frame." “Let the glue dry a little and then fit the back rest sponge.” “Make a small cut to pass the sponge through the seat frame.” "We can now fit the seat covers." “Place the seat covers in front of the seat frame.” “Slide the seat rod into the seat covers.” “Pass the rod through the hole provided in the central bar.” “Insert the ends of the seat rod into the holes provided on the seat frame.” “You can turn the seat now.” “You can now install the back rest cover.” “The seat rod is installed like the front one.” "Make sure you have well tucked into place the connecting band." “Slide into place the lateral seat rod.” “Fold the seat cover over the lateral seat frame bar.” “Insert the ends of the seat rods into the holes provided on the seat frame.” “Wrap the rear seat cover flaps around the seat frame and fix them to the small bar using a hook.” “For the seat covers with side flaps, don’t forget to order an extra set of seat base rods …” "... to correctly finish the installation of the seat covers." “Insert the base rod into the seat cover.” “Pull the end over the seat frame and fix in place with hooks.” “Fix the connecting bands to the seat canvases.” “A big thank you to Christian for helping us out.” “Your seats are now finished and can be refitted into your car.” “As you can see, this operation is not too difficult but requires a lot of time.” “A large selection of seat covers can be found in our catalogue.” “Thank you for your attention. Safe driving.”